Store
J and P Cycles
J&P Cycles, Inc. was founded by John and Jill Parham in 1979. It sells motorcycle components, apparel, and gear for the American V-twin motorcycle rider.
Detail
S&S Cycle Mr103G Gear Drive Camshaft Set For Harley Features: Comes with camshafts and inner gears, this kit is designed for those who are replacing or upgrading an engine already equipped with S&S Cycle gear drive cams, and will be reusing the existing outer gears Installation kit 910-139 is not included but is recommended Fuel injection tuning required. Pinion shaft run-out must be checked before installing S&S gear drive cams. Gear Drive cams should only be used in engines with pinion shaft runout of no more than .003 A hydraulic press and other professional tools are required to install S&S Cycle gear drive cams. Additionally, material must be removed from the inner surface of the stock gearcover. The stock crankcase may require clearancing for S&S Cycle .625, .640, and .675 lift cams. S&S recommends that gear drive cams be installed by a professional mechanic. Due to the inheraent characteristics of gear drives, you may experience more valve train noise with gear driven cams. Oversized and undersized gears are available to help achieve correct gear lash. S&S Cycle has found that with 160 lb. of valve seat force, the S&S Cycle gear drive cams will perform well up to 6200 rpm. If higher rpm is anticipated, valve springs that provide higher seat force should be used. Camshafts that exceed the limits of the stock valve springs require the use of special high lift springs. Most S&S cams have higher lift than stock and are designed to take advantage of the extra flow of ported stock heads or S&S Super Stock heads. Due to the high lift of these cams, S&S adjustable pushrods are recommended. To get the best performance from a performance cam installation, a high flow intake and exhaust system is also recommended. Quick installation and Easy Start Cams allow stock starter to start any engine. Kit contains cams, gearcover gasket, cam bearings, and instructions. 1999-2004 stock springs will handle camshafts with lift up to 0.510. If a camshaft with higher lift is installed, high performance valve springs capable of handling a greater lift must be used. 2005-up stock valve springs will handle camshafts with lift up to 0.585. If a camshaft with higher lift is installed, high performance valve springs capable of handling a greater lift must be used. Cams with over 0.585 of lift will cause interference between the valve spring top collar and the valve seal with stock cylinder heads. Installation of S&S chain drive cams requires special tools. Attempting the cam chan
