Store
J and P Cycles
J&P Cycles, Inc. was founded by John and Jill Parham in 1979. It sells motorcycle components, apparel, and gear for the American V-twin motorcycle rider.
Detail
S&S 585 Cam Kit For Harley Twin Cam Features: Quick installation reuses many stock components Camshafts that exceed the limits of the stock valve springs require the use of special high lift springs. Most S&S cams have higher lift than stock and are designed to take advantage of the extra flow of ported stock heads or S&S Super Stock heads. Due to the high lift of these cams, S&S adjustable pushrods are recommended. To get the best performance from a performance cam installation, a high flow intake and exhaust system is also recommended. Quick installation and Easy Start Cams allow stock starter to start any engine. Kit contains cams, gear cover gasket, cam bearings, and instructions. 1999-2004 stock springs will handle camshafts with lift up to 0.510. If a camshaft with higher lift is installed, high performance valve springs capable of handling a greater lift must be used. 2005-up stock valve springs will handle camshafts with lift up to 0.585. If a camshaft with higher lift is installed, high performance valve springs capable of handling a greater lift must be used. Cams with over 0.585 of lift will cause interference between the valve spring top collar and the valve seal with stock cylinder heads. Installation of S&S chain drive cams requires special tools. Attempting the cam change operation without these tools will be difficult. Damage can result which will not be covered under warranty. S&S Cycle chain drive cams are compatible with the stock splined chain sprocket used in 2000-06 Twin Cam 88 engines, but may be used in 1999 engines if the Harley-Davidson 2000-06 splined rear cam sprocket and appropriate 2000-06 sprocket spacer are used. For lifts over.510 S&S strongly recommends that the stock chain drive cam be upgraded to the S&S Cycle gear drive or to the H-D part number 25284-08. This kit upgrades the problematic spring loaded chain tensioners to more reliable hydraulic tensioners, and also upgrades the oil pump 585 Camshafts are designed for 88 to 95 CID engines with compression ratios from 9.7:1 to 10.5:1 and 100 to 124 CID engines from 9:1 to 10:1 compression. Provides massive horsepower and torque increases starting at 3000rpm and holds steady all the way to redline. 3500-6000 rpm for 88 - 103 engines and 2500-5500 for larger engines
Category
S&S Cycle 585 Cam Kit For Harley Twin Cam
